This Ram 1500 maintenance schedule covers the 5th-generation DT body (2019-2024) – not the carried-over 4th-gen “Classic.” It spans the 3.6L Pentastar V6 with eTorque mild hybrid, the 5.7L HEMI V8 (with and without eTorque) and the 3.0L EcoDiesel V6, all paired with the ZF 8-speed automatic. Like most modern trucks, the Ram schedules oil by an Oil Change Indicator rather than a fixed mileage.
The 5th-generation Ram 1500 (DT) launched for 2019 with a sharper focus on refinement and efficiency. The volume engine is the 3.6L Pentastar V6, which on most DT trucks carries Ram’s eTorque 48-volt mild-hybrid system. The 5.7L HEMI V8 is offered with or without eTorque, and a 3.0L EcoDiesel V6 returned for 2020. Every engine uses the ZF-designed 8-speed automatic (the 8HP family).
Ram does not print a simple mileage table for oil. Instead the truck runs an Oil Change Indicator that watches how you drive and posts a “Change Oil” message when service is due – typically somewhere between 8,000 and 10,000 miles on the gas engines, with a hard ceiling you should never exceed. This guide translates the indicator and the rest of the schedule into real intervals and fluid specs for each engine.
Your Ram watches engine operating conditions and lights a “Oil Change Required” message when the oil is near the end of its useful life – it is not a fixed mileage. On the gas V6 and V8 this usually lands around 8,000-10,000 miles, but Ram also sets a maximum of 10,000 miles or 12 months between changes, whichever comes first, even if the message has not appeared. The EcoDiesel uses its own oil-life logic and spec oil. Reset the indicator after every change.
Ram 1500 maintenance schedule
Ram schedules oil by the Oil Change Indicator; the other items run on the mileage intervals below. Follow the earlier of the indicator message or the time/mileage limit, and shorten everything under severe-duty use (towing, heavy hauling, dust, extended idle).
| Service | Interval | Notes |
|---|---|---|
| Engine Oil & Filter | Indicator / 10K Max | Oil Change Indicator; 10K mi or 12 mo ceiling |
| Tire Rotation | ~8K | Typically paired with the oil change |
| Engine Air Filter | ~30K | Sooner in dusty or off-road use |
| Cabin Air Filter | ~20-30K | Sooner in dusty conditions |
| Transmission Fluid (ZF 8-spd) | ~60K Severe | No fixed normal interval; fluid-for-life only in light duty |
| Spark Plugs (3.6L) | ~100K | 6 plugs; verify interval by year |
| Spark Plugs (5.7L HEMI) | ~100K | 16 plugs – two per cylinder |
| Engine Coolant (Mopar OAT) | 10 Yr / 150K | Purple OAT; then every 5 yr / 100K |
| Brake Fluid | ~2-3 Yr | Flush on condition / moisture content |
| Front & Rear Axle Fluid (4×4) | Severe / Towing | Inspect; change under heavy-duty use |
| Transfer Case Fluid (4×4) | Severe / Towing | Change under heavy-duty use |
Oil Change Specifications
3.6L Pentastar V6 (eTorque) Specs
The 3.6L Pentastar is the standard DT engine and on most trucks carries the eTorque 48-volt mild-hybrid belt-starter-generator. It takes 0W-20 full synthetic meeting Chrysler MS-6395.
5.7L HEMI V8 (eTorque optional) Specs
The 5.7L HEMI is offered with or without eTorque. Both use roughly 7 quarts with a filter. Note the viscosity change: Ram listed 5W-20 (MS-6395) on earlier DT trucks and moved to 0W-20 on the later ones – check your filler cap.
3.0L EcoDiesel V6 Specs
The 3.0L EcoDiesel V6 (Gen 3, 2020+) is a torque-rich turbodiesel. It requires a full-synthetic 5W-40 diesel oil and has a much larger sump than the gas engines. Use only diesel-rated oil meeting the Chrysler spec.
The Oil Change Indicator can read high on easy highway driving, but Ram still caps the gas engines at 10,000 miles or 12 months between changes. Under severe duty – towing, heavy loads, dusty or off-road use, or lots of idling – change oil well before the message appears. On eTorque trucks, use oil that meets MS-6395 exactly; the stop/start system cycles the engine far more often than a conventional truck.
OEM Part Numbers
Genuine Mopar parts keep fitment and warranty coverage right. Engine, model year and 4×4 configuration all change the correct part, so confirm every number against your VIN before ordering – the specs below are the designations to match.
| Component | Part / Spec | Application |
|---|---|---|
| Engine Oil (3.6L / 5.7L) | 0W-20 (MS-6395) | Gas engines; HEMI 5W-20 on earlier yrs |
| Engine Oil (3.0L Diesel) | 5W-40 (MS-12991) | EcoDiesel; full synthetic, diesel-rated |
| Transmission Fluid | ZF 8&9 Speed ATF | ZF 8-speed – NOT ATF+4 |
| Engine Coolant | Mopar OAT (Purple) | MS.90032; 10-yr/150K formula |
| Brake Fluid | DOT 3 | Verify DOT 3 vs DOT 4 by VIN |
| Rear Axle Fluid | 75W-90 (MS-A0160) | +LS additive if limited-slip; HD 75W-140 |
| Front Axle Fluid (4×4) | 75W-85 Synthetic GL-5 | Front differential |
| Transfer Case Fluid (4×4) | ATF (case-specific) | Part-time vs 4WD AUTO differ – verify |
| Spark Plugs (5.7L HEMI) | Iridium (NGK/Mopar) | 16 plugs; verify number by VIN |
| Spark Plugs (3.6L V6) | Iridium (NGK/Mopar) | 6 plugs; verify number by VIN |
Every interval in this guide, tracked for you.
Skip the spreadsheet. Your Ram 1500’s schedule loads automatically and tells you what’s next.
-
Schedule pre-loadedPick your Ram 1500 and the intervals are set up for you.
-
Smart remindersNudges by miles or months, whichever comes first.
-
Full service historyEvery oil change and repair, logged in one place.
4×4 Driveline Service
On a 4×4 Ram 1500, the front and rear differentials and the transfer case all hold gear oil or ATF that is easy to forget – and critical if you tow, haul or drive off-road. Ram lists no routine normal-duty interval, but calls for inspection and a change under severe-duty use.
The rear differential uses roughly 2.6 quarts of 75W-90 gear oil (Chrysler MS-A0160); a limited-slip axle also needs a friction-modifier additive, and some heavy-duty axle ratios specify 75W-140. The front differential on 4×4 trucks holds about 1.7 quarts of 75W-85 synthetic GL-5. The transfer case holds about 1.6 quarts of ATF, but the exact fluid differs between the part-time and 4WD-AUTO cases – match the case on your truck.
On eTorque trucks a 48-volt belt-starter-generator replaces the conventional alternator and feeds a small 48-volt lithium-ion battery pack. It powers an aggressive stop/start and brief torque assist, and is designed to be maintenance-free in normal use. If you see a “Service Stop/Start” or “eTorque System Service Required” message, have the 48V battery, the belt-generator and its grounds checked – and always replace the 12V battery with the correct AGM spec.
| Service | Normal | Severe / Towing |
|---|---|---|
| Rear Axle Fluid | Inspect / fluid-for-life | ~45,000-60,000 mi |
| Front Axle Fluid (4×4) | Inspect | ~45,000-60,000 mi |
| Transfer Case Fluid (4×4) | Inspect | ~45,000-60,000 mi |
| Transmission Fluid (ZF 8-spd) | Fluid-for-life (light duty) | ~60,000 mi |
Severe Conditions Schedule
Ram defines severe operating conditions that call for shorter intervals – and trucks spend far more of their lives there than cars do. If your Ram tows, hauls, plows, idles or works in dust, use the accelerated intervals below.
• Frequent trailer towing or heavy hauling
• Extended idling or low-speed, stop-and-go use
• Driving in dusty, sandy or off-road conditions
• Plowing, commercial or fleet duty
• Short trips in cold weather or sustained extreme heat
| Service | Severe Interval | vs Normal |
|---|---|---|
| Engine Oil & Filter | Well before indicator | Change early |
| Transmission Fluid | ~60,000 mi | vs fluid-for-life |
| Axle & Transfer Case Fluid | ~45,000 mi | vs inspect only |
| Engine Air Filter | ~15,000 mi | ↓ ~50% |
Frequently Asked Questions
Keep your Ram 1500
running forever.
Add your Ram 1500 in 3 minutes. Get automatic reminders for every service interval — track every vehicle from one place.
Cross-shopping full-size trucks? See our complete Chevy Silverado 1500 maintenance schedule for oil, transmission and brake intervals.
